How can 3D printing significantly reduce the time and expense of producing composite tooling? That’s exactly what visitors to the Stratasys booth at SAMPE 2016 came to find out. On display was a full range of tooling solutions for high-end manufacturing applications that demonstrated how 3D printing can replace traditional hard tooling technologies - optimising resources.
If you weren’t lucky enough to spend the week at SAMPE 2016 in sunny Long Beach, California, you can take a quick tour of the Stratasys booth with Tim Schniepp, Stratasys’ Director of Composite Tooling.
You’ll see…
Large layup tool, produced with Stratasys’ ULTEM 1010™ material for a Dassault Falcon Jet interior cabin part.
This large layup tool, produced with Stratasys’ ULTEM 1010™ material for a Dassault Falcon Jet interior cabin part:
Hollow inlet duct from Swift Engineering which was produced using Stratasys’ new Sacrificial Tooling solution.
This hollow inlet duct from Swift Engineering which was produced using Stratasys’ new Sacrificial Tooling solution:
3D printed moulding for rubber manufacturing, including rubber compression moulding, rubber injection moulding and mandrels for rubber overmolding[/caption]
3D printed moulding for rubber manufacturing, including rubber compression moulding, rubber injection moulding and mandrels for rubber overmolding:
SAMPE 2016 was also the debut of the new Stratasys “FDM for Composite Tooling Design Guide” which covers:
